Item: S Works Enduro 2012 Medium
Location: Northern Beaches Sydney
Item Condition: Excellent
Reason for selling: New Bike
Price and price conditions: $1900
It’s time to part with my custom build Enduro that has served me well. I’m a fastidious owner who maintains the bike after each...
Item: Raceface next SL Carbon Bars - 20mm rise, 685mm width.
Location: Mosman or Kingsgrove
Item Condition: New never mounted
Reason for selling: Went with 710's
Price and price conditions: SOLD
Extra Info: These are very light - measured at sub 150gms.
Item: Fox Float 100 RLC. Quick release axle. 1-1/8 steerer 190mm long
Location: Mosman or Kingsgrove NSW
Item Condition: Excellent. No marks on staunchions. Lowers are almost mark free.
Reason for selling: Was saving this lightweight fork for a trail bike build but it's not going to happen...
I picked up this 2012 S works frame from a fellow rotorburner and put this build together for summer. I seriously like light bikes with little compromise ( my M6 DH bike is 33lb and has done two seasons at Thredbo, Val Di Sole etc with no breakage ) so after swapping all the bits from...
Item: SOLD 2008 (I think ) Santa Cruz Nomad Size Large
Location: Sydney - North shore or Kingsgrove
Item Condition: Good Condition. All bearings replaced less than a year ago. Cuastom satin gold paint has a few chips - would consider a repaint in colour of choice for the right price. Custom...
I'm looking to compete (for fun) in some DH races within driving distance of Sydney this year, but I'm struggling to find any info.
Can I ask for posts below with location, race dates if known, and entry fees/requirements?
Just finished rebuilding an Intense M6 I bought a couple of months ago. It needed a lot more work than I'd hoped ( new bearings, pivot pins, and parts ) so I ended up spec'ing it up ( and spending it up! ). Hasn't turned a wheel in anger yet but looking forward to the ride and setting...
I'm a fan of the pivotal seatpost system from BMX ( simple, light, great range of seats ) but have struggled a bit in finding a 30.9mm post to fit my Nomad. Alienation do one but getting it shipped here was a headache, and I'm not a fan of using a shim. So I set about some simple fabrication to...