Search results

It's all good man, honestly I had forgotten about it.

It was Only worth $4M before you put your finger prints on in pushing. Gotta add another $100K being unique now

My shitbox used to to do 115 in 1st but I've changed the gearing for a harder launch and only get 90 now, I think.. I'm pretty busy. 2nd makes bang bang noises at 160. Stupid rev limit.

If you need a flange like this one, I can probably help out.

I'm going to try for Monday. Going with the kids mid week

A mates riding this afternoon, already a couple of ambos called for people who tried too hard.

Having said that, I do have a Chinese set of mics 0 to 150mm that I'm happy with for stuff that's not mega important. You just need to cal them properly. I have a Switzerland made 0-25 mics in microns but it was around $1500 in 1998 That's locked in my gun safe.

Mitutoyo is the only option!

Very nice Cardy. I always use 2 stroke down the throat on first start ups for a long time sitting motor. Don't worry about the steering belt just strong arm it and do some laps 😄

Vn diffs are a good option with good ratios and lsd, cut the long side down so two short axles go in and its the right width. Volvo 240 diffs are bang on for size and strong as. Hilux diffs are almost perfect for width and strong, ratio are the problem like you said. 9" is out, I just don't...

T25 is too small, I have a T28 on my bike and it's great. I'm deciding between the T28 , T3 or even a T3537 for all of those 5500 rpm's haha I have a 186 that will get a hot up once it's all on the road. Rising rate reg off a pitot tube and return fuel line Carb mods to get the boost in all...

Oil pump is fine if you pre fill it, just except the mess putting it together full of oil and the leaks that never go away 😂

I've upgraded to a HR disc front, not great by todays standards but bettererererer than the drums.

The driveline is getting some love too. Currently a 350 Holley... Great at WOT but shit everywhere else. Booooo Because of fuel prices and stuff, I'll need to be more efficient, sooooooo Three 40mm CV carburetors and some boost is the answer to the question I didn't ask.

I bought this when I was 18. 30 years ago it turns out. Drove her a bit late last year but something was wrong. Turns out all the front end bushes were stuffed, I'm going to call for a warranty. New everything under the front, now have to decide on wheels, chromies look cool but I'll go with...

Such a great tool, been using it a bit in my local area

Shed is a mess so you don't get a big picture. I built my bench out of an old pallet rack, they go out of date (somehow) and have to be replaced. You can get it super cheap or free. 19mm yellow tongue on top and you're good to go. 900mm wide x 3000mm long, cut to 950mm high and the vice is at...

Not having a go at you kiwi. "Blended earth" get fucked world trail. Ask them about the peaks trail in the grampians that they built by flying in concrete to make steps. Actually, I look forward to asking myself.

I got this years ago planning for my young bloke to ride. I've changed my mind. It's a good bike, just needs more love than I have time for. Or it goes on hard rubbish tomorrow. The high performance 32mm forks (😁) have been rebuild with new seals and any parts needed. Brakes are shit. What...

Years ago I rode an intense something something at ignition. Wow fancy sexy bike to test ride. What a piece of shit it was. Just because it is expensive doesn't mean it's good. I do ride a rattly old giant reign sx from 2019 but I'm at the pointy end of the group on new Fancy plastic bikes.