Search results

Good god are you still around...? . Last time I was around you were getting banned for 7 days for upsetting people and allsorta shit. Hahahahaa

Byford, bells rapids, Pauls valley ... all unsanctioned

Actually that is a great point. I will do some homework on kinematics of the leverage and leverage ratio.

Hey Folks. Been a while since I posted but it's time to get off facebook and back to actual forums. So brains trust. I want to upgrade the suspension on my 2017 Nukeproof mega 27.5 Alloy. Currently running Monarch plus RT3 . 216 x 63 ML tune. Up front is a 160mm lyrik... first year done so...

I have had a 5 year hiatus from this forum and this was the first thread I read... great post. Glad to be back

Time out... That's about all I have to contribute that already hasn't been said. My wife has a part time job and an active social life with her gym friends. I am a cyclist. Clearly you are too as that's why your on a mtb forum. Make sure you find time to run away and recharge... Both of...

Looks like you guys have it covered... I did the same last year. Just check the end of the hose to see if there in anything jammed in there. I thought I could just reattach the hose when I realised the hose barb was actually quite small, sharp and was snapped clean off in the end of the hose !!!!

182 and I ride a medium enduro... It does feel short in the top tube. But I enjoy that feeling. using your comparison to the stumpy is a tough ask. From memory the enduro has a shorter top tube than the Stumpy for each comparable frame size. Personally, try another specialized dealer to...

I think a lot of forums are dieing. RB has quite a large population for an Australian forum (to its credit). But I do agree with the OP and duck on this topic. People are abandoning conversation for convenience. There seems to be a shift from wanting to "research a topic" to "satisfying an...

I think Jared is far too old and stubborn to be single.:wacko: For the record I have a wife and 3 kids. LOL This is an old setup from a friend that predates even my moto days. But I am determined to keep using it... My chains last longer and my cassette stays cleaner.

This is a specialised paraffin wax and grease formula that is very hard to get nowadays. It sets to a grease like state at room temperature. At around 65degrees it becomes liquid. At about 80-90 degrees it begins to "boil". It only takes about 2-3 minutes and then hang to drip off the excess...

This is how I lube a bicycle chains

hahahahahhahaha

I dont know why.... I just do :tape2: I cant explain it... But she just is. Maybe its the authority.... But Julie Bishop is HOT

Whatever this guy says... do that. if he said bash your mate.... do that to.:dance:

Once again... The duckmeister comes through. Sticky piston sorted. Wheel free spins as much with caliper on as it does off now. Cheers mate.

Cheers duck... Will give that a go tomorrow after work.

So your regularly pedalling your downhill bike up hills and on flow trails.... Read my posts. The CCDB is fine in your application. Which is why I haven't made the call to sell mine yet. Moorey makes a good point about getting the shock tuned... I would have the low speed rebound needle...

The rear is the problem child. But even the front could be classed as noisey but it free spins ok. Good point about the bleeding. I usually leave the old pads in or use the blocks supplied in the avid kit.

Try Formula... Did someone say light switch?!?! The engineering department at Formula clearly stopped learning the alphabet at "l" ..... "Modulation? What's that weirdo concept"