beeb
Dr. Beebenson, PhD HA, ST, Offset (hons)
All items located in Shepparton, VIC. Can arrange freight around Aus for cost of shipping, typically it's around $15. If you want any extra pictures just ask and I'll post them in here or MMS them to you.
Item: Shimano XT 10-51T drivetrain groupset (minus chain).
Item Condition: Excellent, minimal use (ie: less than 100km). Couple of minor scuff marks on crank arm protective tape, one small rock-graze on NDS crank arm near clamping bolts.
Reason for selling: Not riding MTB currently...
Price and price conditions: $250 SOLD (Pending)
Extra Info: XT M8100 bar-clamp shifter, XT M8120 (Boost) 170mm cranks, XT SM-CRM85 32T chainring, MT800 BB, XT M8100 derailleur, XT M8100 10-51t cassette - Add a chain and you're up and running.
Pictures:
Item: Shimano XT/XTR 10-45T drivetrain groupset (minus chain)
Item Condition: Excellent, minimal use (~100-200km). Must've reused/ridden a bit further on these cranks compared to the other parts - as they are a bit more scuffed up with heel rub than the other set - they have just worn through the anodising on one edge of the drive-side arm. All other parts are very low km.
Reason for selling: Not riding MTB currently...
Price and price conditions: $240 SOLD (Pending)
Extra Info: XT M8100 bar-clamp shifter, XT M8120 (Boost) 170mm cranks*, XT SM-CRM85 30T chainring, MT800 BB, XTR M9100 derailleur, XT M8100 10-45t cassette. Add a chain and you're up and running.
*PLEASE NOTE: These have non-Genuine crank spacer washers included/installed as I lost the originals. They look a bit bodgy but work fine in practice.
Pictures:
Various items - see listings below picture.
Item: Fabric Scoop Flat Saddle (left of pic)
Item Condition: Excellent, fabric logo slightly scuffed off - otherwise like new.
Reason for selling: Surplus to requirement
Price and price conditions: $50 SOLD (Pending)
Extra Info: Hint of ducktail at the rear, complaint 'chassis' and smooth covering. Good all-rounder.
Item: Ritchey Classic Saddle (centre of pic)
Item Condition: Excellent, fabric logo slightly scuffed off - otherwise like new.
Reason for selling: Surplus to requirement
Price and price conditions: $50 SOLD (Pending)
Extra Info: Reasonably pronounced ducktail at rear, rounded shape, reasonably complaint 'chassis', saddle top has perforated covering (adds a little grip IMO). If you like the rounded shape it is an excellent saddle for those who like seated climbing.
Item: Ergon SME-3 Saddle (right of pic)
Item Condition: Good, minor tear on rear R/H corner (approx 4mm semi-circle, could probably be glued down)
Reason for selling: Surplus to requirement
Price and price conditions: $30 SOLD (Pending)
Extra Info: Very flat with slight central relief. Not too stiff in the chassis. Covering can be a bit slippery which can either be good or bad depending on preferences - Flat profile and not too grippy would work well for those who can throw stylish tricks (ie: Not me!).
Item: Formula 203mm 'Monolithic' brake rotors x2
Item Condition: New in packaging
Reason for selling: Surplus to requirement
Price and price conditions: $60 for the pair SOLD (Pending)
Extra Info: Have used these in the past, tend to add a little extra bite for the same size rotor compared to Hope rotors.
Item: Hope 50mm 31.8 clamp DH stem.
Item Condition: Good. Looks a touch drab/some very very minor scuffs in places
Reason for selling: Surplus to requirement.
Price and price conditions: $40 SOLD (Pending)
Extra Info: Could possibly be used to crack bank vaults. Incredibly sturdy. Bolts take a 5mm allen key.
Item: ZS44/28.6 - ZS56/40 Headsets - Acros and Carbonda (Carbonda one has ~16 riser top cap).
Item Condition: Acros is new in packaging, Carbonda new but loose.
Reason for selling: Surplus to requirement.
Price and price conditions: $40 for both. SOLD (Pending)
Extra Info: Found the Acros while digging through some parcel packing earlier this week, standard issue from RAAW for the Madonna apparently. Carbonda headset is actually really good quality, comes with a split crown-race from new. Can included random star-nuts and probably even a steerer top-cap if required.
Item Condition: Excellent, minimal use (ie: less than 100km). Couple of minor scuff marks on crank arm protective tape, one small rock-graze on NDS crank arm near clamping bolts.
Reason for selling: Not riding MTB currently...
Price and price conditions: $250
Item Condition: Excellent, minimal use (~100-200km). Must've reused/ridden a bit further on these cranks compared to the other parts - as they are a bit more scuffed up with heel rub than the other set - they have just worn through the anodising on one edge of the drive-side arm. All other parts are very low km.
Reason for selling: Not riding MTB currently...
Price and price conditions: $240
*PLEASE NOTE: These have non-Genuine crank spacer washers included/installed as I lost the originals. They look a bit bodgy but work fine in practice.
Various items - see listings below picture.
Item Condition: Excellent, fabric logo slightly scuffed off - otherwise like new.
Reason for selling: Surplus to requirement
Price and price conditions: $50
Item Condition: Excellent, fabric logo slightly scuffed off - otherwise like new.
Reason for selling: Surplus to requirement
Price and price conditions: $50
Item Condition: Good, minor tear on rear R/H corner (approx 4mm semi-circle, could probably be glued down)
Reason for selling: Surplus to requirement
Price and price conditions: $30
Item Condition: New in packaging
Reason for selling: Surplus to requirement
Price and price conditions: $60 for the pair
Item: Hope 50mm 31.8 clamp DH stem.
Item Condition: Good. Looks a touch drab/some very very minor scuffs in places
Reason for selling: Surplus to requirement.
Price and price conditions: $40
Item Condition: Acros is new in packaging, Carbonda new but loose.
Reason for selling: Surplus to requirement.
Price and price conditions: $40 for both.
Last edited:
