tkdbboy
Likes Dirt
Hey brains trust,
Just want to confirm some in/sanity and see if anyone's run this combo.
I got a new wheel built on a DT 350 CL Hub (Hibike stopped selling the 6 bolt one) and figured I could just get the CL -> 6 Bolt adapter.
When putting them together, the centre piece of the Hope rotor has recesses (rather than a completely flat one piece rotor like most) which doesn't allow for the washer to sit on and seat into the 6 bolts on the other side of the adapter. The washer has grooves that mates with the top clamp like a cassette clamp.
I believe my options are:
Cheers!
Just want to confirm some in/sanity and see if anyone's run this combo.
I got a new wheel built on a DT 350 CL Hub (Hibike stopped selling the 6 bolt one) and figured I could just get the CL -> 6 Bolt adapter.
When putting them together, the centre piece of the Hope rotor has recesses (rather than a completely flat one piece rotor like most) which doesn't allow for the washer to sit on and seat into the 6 bolts on the other side of the adapter. The washer has grooves that mates with the top clamp like a cassette clamp.
I believe my options are:
- Dremel the body of the rotor to allow the washer to sit flush.
- YOLO no washer and potentially damage the rotor body and hope I can remove it in the future after its torqued to 40nm
- Use regular rotors (I've got some spare Centrelines but #HopeMatchyMatchy)
- Buy a new bike
Cheers!
Attachments
-
53.2 KB Views: 45
-
79.7 KB Views: 46
-
125.6 KB Views: 48
-
90.1 KB Views: 50