Pivot Point setup

Oddjob

Wheel size expert
Mattocs are 27.5" so you will want to run it with 10mm less travel again to compensate for extra axle-to-crown length.
Best bet would be to use the fox 32's for now until you are ready to buy a better 26" dj fork.
The bikes designed to run 100-120mm (or 130 at a stretch). So I'm hoping the Mattocs satisfy the upgradeitis, otherwise its Fox 36 time.

Sent from my SM-G900I using Tapatalk
 

Oddjob

Wheel size expert
Nope. Pretty much stripping everything off it.

Hubs will be Hope Pro 2 15x100 front, 10×135mm bolt up rear. Mavic 721 rims. Kenda small block 8s.

Fox 32 forks. Rf turbine 170mm cranks. X9 1x10 gears. Vp harrier dh5 pedals.

Sent from my SM-G900I using Tapatalk
 

Ultra Lord

Beanie Fitment Specialist
Spewing they’re 15mm axle forks, if t was 20 I’d have taken em off you when you swapped em out.
 

Oddjob

Wheel size expert
Spewing they’re 15mm axle forks, if t was 20 I’d have taken em off you when you swapped em out.
The Fox 36 are 20mm. I actually just sold a set of Marz am sl1s that were 20mm. Spewing.

Sent from my SM-G900I using Tapatalk
 

Ultra Lord

Beanie Fitment Specialist
Trying to lighten the bike, 36’s are too heavy. The argyles I have weight a metric buttload.

Those manipoo circus’s posted earlier are very, very tempting but I’m too tight to fork out 350 for a set.
 

pink poodle

Our man in Japan
Trying to lighten the bike, 36’s are too heavy. The argyles I have weight a metric buttload.

Those manipoo circus’s posted earlier are very, very tempting but I’m too tight to fork out 350 for a set.
Fucking tradies...just buy them! You'll be stoked, the price is awesome, they seem a nice fork. Be happy, the house can wait, you just did all that over time...
 
Top