VIC Stan’s 135qr end caps Found!!

glenn1529

Likes Dirt
Item: Stan’s 3.30 ti type 2 rear wheel 135 qr end caps, for shimano driver
Location: I’m in Wodonga, VIC
Item Condition: not screwed
Reason for needing: skinny frame
Price and price conditions: cheap’s good, I’m sure there’s thousands out there, sitting neglected in parts boxes. Give them a new life!
Extra Info: Australia has ten times more Camels than Koalas
 
Last edited:

Plankosaurus

Spongeplank Dalepantski
I might, do you know if the Ti is the same size as standard? I know HD is different but haven't had anything to do with the Ti ones...

Sent from my G8441 using Tapatalk
 

glenn1529

Likes Dirt
Hey Planko,
As far as I can work out, they’re the same. As long as they’re type 2, which have one threaded, one push fit end. Oh, and different between shimano or XD drivers, I need shimano type.
Cheers.
 

Plankosaurus

Spongeplank Dalepantski
Looks like 2 threaded ends

It's off a standard 3.30 hub, Shimano driver (I don't believe in xd). Let me know if you think this is going to work...


Sent from my G8441 using Tapatalk
 

sane

Likes Bikes and Dirt
I have this, threaded 1 end, from a 3.30. Will it get you out of trouble?

6B67563B-8461-4398-9C29-FDDAD3E39833.jpeg
 

glenn1529

Likes Dirt
Thanks Plankosaurus, but I don’t think that one will work.

Sane, if the shaft diameter is 15mm and 55mm across the bearing shoulders it should be a go-er. Let me know what you want for it.

Cheers.
 

glenn1529

Likes Dirt
Can’t find washers on any diagram online. Are the axle and caps from a shimano or XD driver? If it’s XD, washers may have something to do with it.
 
Top