Mmmm donuts.Is it time for Highlander's to become the new Grom Donuts?
Memory says that the manufacturer of my BB says to go to 40nm. Don’t have a torque wrench that goes that high so snugged it up. Weird it unscrewed. Will pull it all apart tomorrow and see what is going onIt will be fine, mines been around the frame at least twice. The issue is the actual carbon frame has the locating Alu insert that the BB tube locates in. Looks like I have just rounded flats on the tube but wouldn't surprise me if I've done some rounding to the fat frame shell too.
Will send Deviate this vid I took a couple of days ago and see what they say.
I'm a bit anal when tightening BBs, on the excessive side. So 100% my fault.