willsy01
Eats Squid
So i'm servicing the forks (open bath Fox 32 F100RL).....air side is done, damper side has thrown me a curve ball though.
I've dropped the damper back in and put a few turns on the top cap, the threaded part is poking out through the bottom and i've started screwing on the nut and crush washer.....now comes the problem. The threaded rod is spinning within the damper and it isn't even close to being tight enough.
I've tried compressing the fork to put some pressure on the damper rod hoping it would be enough for it to tighten but no dice. Short of cutting a slot in the damper rod, any tricks to get the bastard tightened?
I've dropped the damper back in and put a few turns on the top cap, the threaded part is poking out through the bottom and i've started screwing on the nut and crush washer.....now comes the problem. The threaded rod is spinning within the damper and it isn't even close to being tight enough.
I've tried compressing the fork to put some pressure on the damper rod hoping it would be enough for it to tighten but no dice. Short of cutting a slot in the damper rod, any tricks to get the bastard tightened?