safreek
*******
Would this be easyHope should convert to regular
Would this be easyHope should convert to regular
Have a looksey through here https://forums.mtbr.com/yeti/asx-setup-thread-365398.html should be plenty off answers.I have got to check the bb measurements, I have to confirm that it is the correct cranky size, planky has made me doubt myself
My hope BB has a 1mm thick spacer/shim that sits in NDS bearing to make it up to 24mm. Remove it to make that side 22 for GXP cranks.Would this be easy
Seems like the frame is pretty short, the measurement for the rear seems like about 1340ish. I am prepared to get a longer hose if needed, I like the older bizzoCost of freight would suffice mate, they've been sitting in storage for too long lol. I don't have any spare rotors though. Oh, and I think one of the allen key bolts might be a bit rounded out from memory but you can grab spare bolts from a bolts and fasteners place or just jam a bigger allen key in it, or torx works too haha. Want me to measure hose lengths? The last bike they were on was a medium 26" hardtail so the rear may be a bit short.
Let me know!
Cool, I'll check them tomorrow after work. Too cold and disorganised in the shed at the momentSeems like the frame is pretty short, the measurement for the rear seems like about 1340ish. I am prepared to get a longer hose if needed, I like the older bizzo
No little spacer, does that mean a normal shimano axle will fit?My hope BB has a 1mm thick spacer/shim that sits in NDS bearing to make it up to 24mm. Remove it to make that side 22 for GXP cranks.
Does your BB have one of these in NDS?
https://www.mtbdirect.com.au/hope-b...V13WO2kBkVyUpso7RCrTPVIOZTpF9He0aAovqEALw_wcB
Cheers bro, that's fantasticCool, I'll check them tomorrow after work. Too cold and disorganised in the shed at the moment
But they've got your name on it
I think so. Bang a Shimano/RF etc 24mm in...or just measure if both sides are 24mmNo little spacer, does that mean a normal shimano axle will fit? View attachment 355105
Sweet, thanks for that, shall test in the morning when motivated to pull apart the other bikeI think so. Bang a Shimano/RF etc 24mm in...or just measure if both sides are 24mm
Rear hose measured 1240mm from lever to caliper. But any sram/avid hose will work to make it longer. Front is a pretty standard 730mm. New pads too by the looks lol. Genuine one owner brakes, only used on SundaysSeems like the frame is pretty short, the measurement for the rear seems like about 1340ish. I am prepared to get a longer hose if needed, I like the older bizzo
Hi mate, would certainly be interested in one of your bars, pmingIf Poodles don't work I have a couple of sets of bars I can send cheap. 750mm one and 740mm. Both 31.8
But did the little old lady ride them to church. PmedRear hose measured 1240mm from lever to caliper. But any sram/avid hose will work to make it longer. Front is a pretty standard 730mm. New pads too by the looks lol. Genuine one owner brakes, only used on Sundays