Only applied a little grease to the thread on the pedal spindle, as I personally think it’s a good idea when fitting parts together that you would like to dismantle in the future. So the grease didn’t solve a thing. Nipping the cranks up on the BB axle did the trick.
To remove a press fit cup...
Agreed.
I tightened the crank arm a bit, removed the pedals and smeared a small amount of grease on the thread and retightened. The creak seems to be gone for now. I was up the hill yesterday and stoped in to the BS and asked old mate what he thinks about it, he was advising removing the cups...
Yeah, I have the SRAM set (X1). So is there any chance of preloading the bearings if over tightened?
How does 40Nm sound on the crank bolt? Not sure I dig this one bolt on the ND side setup. What’s wrong with Ye Old setup with a crank bolt per side? Thanks for the replies too.
New bike Couple (yes 2 rides) of rides now creak’n from down there and want check the torque of BB. Enough noise to piss me on a new ride. Will swap pedals out today just to confirm. Info please.
I know these guys are gone but if someone has a box of them somewhere i'll buy four. Also if anybody knows of a simliar product being made let me know. Am I the last dude bang'n his knees here?
Just wondering if anybody knows of a contact for AI.
I have a set hubs and after some parts, but seem to of disappeared. (from the web anyway)
Sure they were in Mudgee there abouts.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.