got width

Status
Not open for further replies.
trouble

trouble

Likes Bikes and Dirt
OK, heres my theory; it's either photoshopped, but I've been recently welding in dt, and you can see halfway along tidy cleaned up welding looking marks, so you have welded on extensions...that's my guess? Otherwise I'd say good photoshop?
 
Pete_10

Pete_10

Likes Bikes and Dirt
trouble said:
OK, heres my theory; it's either photoshopped, but I've been recently welding in dt, and you can see halfway along tidy cleaned up welding looking marks, so you have welded on extensions...that's my guess? Otherwise I'd say good photoshop?
Click to expand...
I wouldn't say welded. They look like 800's to me.
 
Riedy

Riedy

Likes Dirt
Your brakes are turned around so they are on the wrong way
jeeeezz i dont know.
 
Last edited:
RYDA

RYDA

Likes Bikes and Dirt
Ok ive got it.


Well.

in the left hand bottom corner there is a case with W on it.

then the screwdriver makes an I

then the tape measure makes a D

then the bars make a T

then the headtube/forks make a H



What do I win?
 
dezza10

dezza10

Likes Dirt
RYDA said:
Ok ive got it.


Well.

in the left hand bottom corner there is a case with W on it.

then the screwdriver makes an I

then the tape measure makes a D

then the bars make a T

then the headtube/forks make a H



What do I win?
Click to expand...


Are you serious?

how did you see that? i could barely see it and i was looking for it..
 
a-line

a-line

Likes Dirt
i cant take it anymore, im sick of looking at the picture, IM AN ADDICT! put me out of my misery, WHAT is so special about it????
 
J

Jagman

Likes Bikes
You've welded extensions on, you can see the left hand weld just to the right of the left hand brake reservoir. The light is reflecting differently showing where you've ground the welds down and painted over, and you can see the very slight change in angle of the bars, where you haven't gotten the extension exactly in alignment.

I hope you either put another rod inside to support the extension or these are just for show, the bar wall thickness wasn't designed to have the weight loading so far from the attachment point.
 
Z

zaccyboy

Likes Bikes and Dirt
The bottom part of your head tube looks to close to your downtube.?
And it also looks like their is a crease mark there?
Is that right??
 
BUSHPIG

BUSHPIG

Likes Bikes and Dirt
RYDA said:
Ok ive got it.


Well.

in the left hand bottom corner there is a case with W on it.

then the screwdriver makes an I

then the tape measure makes a D

then the bars make a T

then the headtube/forks make a H



What do I win?
Click to expand...
Your good, very good. But that's not it...
 
Status
Not open for further replies.
Top