PF30 BB facing and reaming tool

[curlysurfer]

Hi folks,

Does anyone have or know of a shop that has the tool listed above?

I'm building 2 frames from scratch, and that's the only ream I don't have access too, albeit without forking out 1 kidney from my firstborn.

Last resort will be to have them set up in a mill and bore them out. I'm on the NSW central coast and willing to travel a little bit to get it sorted.

Cheers
Rob

 

[redbruce]

Hi folks,

Does anyone have or know of a shop that has the tool listed above?

I'm building 2 frames from scratch, and that's the only ream I don't have access too, albeit without forking out 1 kidney from my firstborn.

Last resort will be to have them set up in a mill and bore them out. I'm on the NSW central coast and willing to travel a little bit to get it sorted.

Cheers
Rob

Unless a cheapo frame, they should be fine from factory.

In my experience PF30 is far less critical than traditional screw thread in alignment.

 

[curlysurfer]

Thanks RB, but I've gotten a bit of distortion from the welding, 0.35mm out of round, and they come undersize purely for reaming after welding.