Twenty6 Ti Pedal problem

[jamie]

I am after some help with my pedals; they have developed a creek when under load. I have pulled these apart and regreased; the outer bush area has signs of some wear along with its adjoining nylon locking bush (possibly I have over tightened these at some stage)
Any suggestion on rectifying this problem would be much appreciated
Is there a bushing kit available?
And can I purchase some additional pins for these also, i have tried to PM Nicho but no answer
Thanks again Jamie

 

[indica]

they have developed a creek

Move them out of the rain.

 

[ovadahill]

Could be the bottom bracket creaking

 

[ToranaJudd]

Have the same pedals dude...

Creaking was there from day 1. I think it's a Ti thing of the fact they are tight so the pedal doesn't spin freely. I like the fact it stays horizonal unloaded.

Gone thru a set of pins once too. Nicho ignored my PM. Look on CRC, there are some traction pins with a hex base. A little heavier, but they work just as well and are more durable.

Judd

 

[fairy1]

You could try emailing Rouler, pretty sure it's more than just Nicho, may be wrong though.

 

[Nerf Herder]

And can I purchase some additional pins for these also, i have tried to PM Nicho but no answer

did you buy them from an LBS ... your LBS can deal with the Distro much quicker. Nicho likely gets a bazillion PMs so maybe go through his business contact details.
http://www.rouler.com.au/contact/index.php

I'd check your cranks too as mentioned above

 

[jamie]

thanks all, ill get onto rouler and keep you posted

 

[floody]

Move them out of the rain.

Sorry, indulge me...

Reminds me of getting a workshop job that said 'find mystery creek'.

I believe its near Waikato in NZ.

 

[nicho]

Hello everyone,

SORRY for the delay in my response but i really don't come on here much these days.
Anyway it's not an excuse.

Let me just get through my pm's and i will get back to the respective parties.

Cheers

Nicho

 

[jamie]

Hello everyone,

SORRY for the delay in my response but i really don't come on here much these days.
Anyway it's not an excuse.

Let me just get through my pm's and i will get back to the respective parties.

Cheers

Nicho

much appreciated thanks

ps i have also sent this request direct to the Rouler site

 

[jamie]

both nicho and tyler from twenty6 US have been in touch with me and working on a solution, ill keep you posted with the result