rowdyflat
chez le médecin
So my hack worked and I got the bearings out.
The new bearings arrived and I have been tapping them into the yoke but it is tricky to get them in square especially as the SC yoke is quite assymetrical .
I have greased them then used a socket which sits on the outer race and use a hammer .
I have a vice , would that press them in better ?
Has anyone made a press from threaded rod and nuts and washers ?
The new bearings arrived and I have been tapping them into the yoke but it is tricky to get them in square especially as the SC yoke is quite assymetrical .
I have greased them then used a socket which sits on the outer race and use a hammer .
I have a vice , would that press them in better ?
Has anyone made a press from threaded rod and nuts and washers ?