whitey89
Likes Bikes and Dirt
The head has snapped off two bolts holding the axle on my fox 40's (see image) I have tried drilling through them in the hope to get an easyout in there but i cant get deep enough down before either the drill bit snaps or stops eating away.
I managed to get one of them out by slowly drilling down about 3-4mm using WD40 and a slow drill speed and then sticking the drill in reverse and luckily it came out, the other one is a little harder to get in to.
Is there a special type of drill bit i should be using? I was using brand new bits but even they dont work too well...
I managed to get one of them out by slowly drilling down about 3-4mm using WD40 and a slow drill speed and then sticking the drill in reverse and luckily it came out, the other one is a little harder to get in to.
Is there a special type of drill bit i should be using? I was using brand new bits but even they dont work too well...