I actually use bear outdoor masking tape.. I had s failure with it on my road bike but that was at 90psi. On my mountain bike it's perfect. Won't use stans again now..
This stuff?? http://www.bunnings.com.au/norton-bear-25mm-x-50m-super-blue-outdoor-long-life-masking-tape_p1661596
Has been working well for me for 3 months so far.
Stans is $20 on sale in Pushys at the minute. Why not just buy tape that's designed for purpose rather than taking a gamble on something that's possibly hit and miss?
$20 = six pack of beer.........flat tyre and walking X km out of a trail...= pain in the arse.
Cheaper again on MTB Direct. :Banane45:
Stans is $20 on sale in Pushys at the minute. Why not just buy tape that's designed for purpose rather than taking a gamble on something that's possibly hit and miss?
$20 = six pack of beer.........flat tyre and walking X km out of a trail...= pain in the arse.
Since I swapped to Gorilla tape 4yrs ago.....I haven't had an issue of premature slip.
All tapes will slip inwards over time and pressure though, GT gives me the most tyre removal/installs (usually 3) before I have to retape the rim....with Stans/other it is a re-tape after each tyre removal as the tape had slipped in too far to guarantee it to seal.
I'm not convinced you're installing your tape right if it "slips".
Proper clean with isopropyl, roll the tape on tight and use a Tyre lever to press the middle and edges down firmly and mine don't move.
Been using gorilla tape...