Where does the hammer go?Modified the bearing drifts slightly, now both sides can locate into the bearings ID. Makes pulling bearings in square child's play. All those times fucking about with flat drifts that didn't locate into the bearing, grrr.
Takes a lot to stop the little mechanic testing the carbons integrity with a hammer.Where does the hammer go?
Sent from my SM-G900I using Tapatalk
What do you use in the ultrasonic bath and how long you leave it on for? We have one at work but not sure how to use it effectively.Uppers and lowers fully ultrasonic washed with help from the little mechanic.
Mmmmmm ask Link about his XX1 42 toothWhat do you use in the ultrasonic bath and how long you leave it on for? We have one at work but not sure how to use it effectively.
How long you leave something like a cassette in there for?I clean pretty much anything that will fit in the ultrasonic bath. Be careful with painted and anodised parts.
Solution is tap water with a bit of dishwashing detergent. I make the water approx 50c that I put in.
10-20 mins, depends how dirty. I use dry lube most of the year and it comes off nicely.How long you leave something like a cassette in there for?
So when and where will we be able to buy all these tools from you??Beginnings of a 35mm fork seal driver. Tried to make it out of one piece of 40mm long stock, but stuffed it up. Will now be a two piece, brazed together assembly, with a 35mm OD section that locates into the upper bushing of the lowers.
I don't think I compete against mass produced products, these are just for myself. But I'll have a look and a think.So when and where will we be able to buy all these tools from you??
Unintended consequenceSo it will push the seals in under self weight? Could you say automatic seal installation device?