moorey
call me Mia
I can’t imagine so. Further investigation after I try it. That’s months away.
Confessions from the fuckwits
- Thread starter moorey
- Start date
dazz
Downhill Dazz
Asininedrivel
caviar connoisseur
How long until the frame is in stock?
PJO
in me vL comy
Wolftooth make one. Not sure on availablity.
Wolf Tooth Lower Headset Cup Extender - ZS - Zero Stack
This Wolf Tooth Precision Zero Stack (ZS) headset features Enduro stainless steel bearings and custom designed seals is for frames with internal bearing cups. These lower headset cup extenders allow you to adjust the geometry of your bike frame by increasing the effective fork length by 10mm.
www.wolftoothcomponents.com
Don't spoil our fun in speculating.
moorey
call me Mia
Biggest factor is finding one that is close to the huuuuuuge HT diameter of the tranny.....it looks huuuuge anyway. Maybe it's just the top.Wolftooth make one. Not sure on availablity.
Wolf Tooth Lower Headset Cup Extender - ZS - Zero Stack
This Wolf Tooth Precision Zero Stack (ZS) headset features Enduro stainless steel bearings and custom designed seals is for frames with internal bearing cups. These lower headset cup extenders allow you to adjust the geometry of your bike frame by increasing the effective fork length by 10mm.
Don't spoil our fun in speculating.
PJO
in me vL comy
It's 56 top and bottom. So yes will look bigger than a tapered 44/56.
moorey
call me Mia
It’s more of a nap fest mid way I’m told.
The Duckmeister
Has a juicy midrange
It steps out at the centre. Top is 56mm OD to fit into the frame, bottom is 56mm ID to replicate the frame & fit the headset in. So lower half OD will be nudging 62mm depending on wall thickness.
Ultra Lord
Hurts. Requires Money. And is nerdy.
Just run 29 up front. It’s a whole new bike, it’ll take awhile to get used to it anyway.
Storm in in a teacup, you’ll love it.
moorey
call me Mia
beeb
Dr. Beebenson, PhD HA, ST, Offset (hons)
Rotorburn will prevail. We will find a way. You will become one of us!
The crowds murmurs, and slowly begins to chant, "One of us... ...one of us..."
The Duckmeister
Has a juicy midrange
Then I get dibs on all the 26" stuff!! 
beeb
Dr. Beebenson, PhD HA, ST, Offset (hons)
@Plankosaurus is already loading up the mystery van! Better get there quick!Then I get dibs on all the 26" stuff!!
hifiandmtb
Sphincter beanie
Cannondale enters the chat:
fatboyonabike
Captain oblivious
should have been expressed as "4/5ths of FA"...who has access to a torque wrench that measures under 1Nm?
Pivot sell a 17mm cup. I’m running one on my switchblade. Could be an option. Might no a bloke that could send you one as well
gooGle gives me this:
https://production-privee.com/products/hs-extension
I reckon sell some stuff from the back of the shed and go 29 on the front. Run it as they intended.
https://production-privee.com/products/hs-extension
I reckon sell some stuff from the back of the shed and go 29 on the front. Run it as they intended.