Think it's when you spend a lot of time at the library
The QUICK question thread.....
- Thread starter Minlak
- Start date
Cheers. Fingers crossed but given it’s been sitting so long now not holding out much hope.
Ultra Lord
Hurts. Requires Money. And is nerdy.
Could be argyle 409's?
RS air sprung dj forks. Shame no 20mm through axle though, I'd look up that fork and see if they came with those lowers or not.
Older than 3 years though I'm pretty sure. They stopped making them when they brought out the pike dj.
RS air sprung dj forks. Shame no 20mm through axle though, I'd look up that fork and see if they came with those lowers or not.
Older than 3 years though I'm pretty sure. They stopped making them when they brought out the pike dj.
Flow-Rider
Burner
They look like recon 351 lowers, can't really tell in that pic if the stanchions are steel but not the correct damper knob for an argyle.
moorey
call me Mia
I think he meant 13.
moorey
call me Mia
Yeah, I’d say 2010/11 at a best guess.
Flow-Rider
Burner
Got to be around the older 10 year mark with the rounded top arch.
pink poodle
ここには見るべきものは何もありません
I didn't think I'd seen argyles without a 20mm axle. I reckon they are a low end fork picked up to replace something really old. The nutted axle is just a carry on from their predecessor.
@creaky perhaps you can figure them it with the rs serial number?
moorey
call me Mia
Tending to agree now.
These are 06, 07 and 09 (rev/Reba/Reba)
By 09 the arch was squared off I think they’re Recons
The Duckmeister
Has a juicy midrange
Stanchions are anodised aluminium, so Recon at least. No "power bulge" in the lower leg makes it pre-2010. MoCo damper logo on crown - not complete shit, not amazing either, but somewhat adequate for the estimated vintage. Turn Key non-remote knob was widely used across the range, so that's possibly not a great identifier..... Travel could be its main identity point.
Flow-Rider
Burner
You can't get a turn key in an argyle as they all had these with the adjustable floodgate.
moorey
call me Mia
- Split race.
- Tap on with a mallet and a block of solid wood. Going gently around and keeping it all even. I’ve never owned a proper tool. I never will.
mike14
Likes Bikes and Dirt
cokeonspecialtwodollars
Fartes of Portingale
Was it on here recently somewhere that someone posted up a stainless nalgene style water bottle was the perfect size?
moorey
call me Mia
He said DODGY, people.
wkkie
It's Not Easy Being Green
Take the crown race to Bunnings / plumbing place. Buy at least a 30cm length of the pipe that fits around the crown race. Done.